womixcity.com

Diy Glitter Card. A card tissue paper glue glitter cut out a square of tissue paper, then cut the square into two differently sized rectangles. Get up to 35% off.

Old plates with die cut marks can show up on your foiled piece, so make sure that gel is very dry. Sprinkle an even layer of glitter over the stencil. Prepare the design for the design you can either use a stencil or draw it on the black paper.

Sprinkle an even layer of glitter over the stencil.

Diy pink glitter thank you card. Prepare the design for the design you can either use a stencil or draw it on the black paper. I used the grass stencil, as well as the bunny and chick! This crafty mouse pad will look awesome on your desk and be a practical addition, too!

These are instructions to make a glitter bomb card you will need: Large sheet of textured glitter card. Prepare the design for the design you can either use a stencil or draw it on the black paper. I used the grass stencil, as well as the bunny and chick!

Place one sheet on each side of the red card stock, making sure that they are centered, and press firmly on the white paper. I used the grass stencil, as well as the bunny and chick! Every design is different, but i used the glitter tape as an accent for the front of the card for the christmas tree, i started with the tree design using a sharpie, and i used a hole punch to create circular. Place one sheet on each side of the red card stock, making sure that they are centered, and press firmly on the white paper.

Lay the card sticky side up in one glitter tray and gently sprinkle the card with white glitter. Sprinkle an even layer of glitter over the stencil. Glitter mouse pads brit all i can say is “wow.” amazing the difference a little glitter can make. You can use mod podge, glossy accents, diamond glaze or anything like that.

You can use mod podge, glossy accents, diamond glaze or anything like that. Then move to next glitter tray to sprinkle with second glitter. Lay the card sticky side up in one glitter tray and gently sprinkle the card with white glitter. Using either the end of your paint brush or a pencil, tightly wrap beading wire around the end.

After your pumpkin has fully dried, gently tap the pumpkin to knock off any excess glitter. Next time i might top it with copy paper to see if that helps to prevent the marks in the plates from showing in the foil. Pink, blue, gold, silver glitter, however to decide? Get up to 35% off.

Every design is different, but i used the glitter tape as an accent for the front of the card for the christmas tree, i started with the tree design using a sharpie, and i used a hole punch to create circular. Use a foam brush to apply a thin layer of mod podge within the stencil. Cool diy craft ideas made with glitter 1. Find some inspiration in our gallery or on pinterest perfect for spring, summer, winter

Place one sheet on each side of the red card stock, making sure that they are centered, and press firmly on the white paper. Wrap a section a little longer than the length of the pumpkin stem. You can get crinkles if you run it through twice. Find some inspiration in our gallery or on pinterest perfect for spring, summer, winter

Don’t worry, it will be covered by the glue and glitter and won’t show in the end. Pink, blue, gold, silver glitter, however to decide? Today's challenge was to design your own glittered blossoms by adding glitter to the tips or entire blossom to create your own fancy embellishments. Lay the card sticky side up in one glitter tray and gently sprinkle the card with white glitter.